HTV - heat transfer vinyl. I use high quality Stahl's vinyl.
** You must use masking tape
*****Do not mirror design when cutting.
After cutting & weeding----
Step 1: Remove mask from liner.
Step 2: Position mask over weeded design. Use a squeegee to eliminate air bubbles.
Step 3: Remove design from carrier by pulling at a 90 degree angle.
Step 4: Place masked design back on liner until ready to heat apply.
Save the mask liner to use with the masked design.
Wait 5 Seconds, Peel Warm
100% Pre-Shrunk Cotton
Machine wash inside-out using mild detergent.